Open Access Green as soon as Postprint is submitted to ZB.
To the relevant diameter of aerosol particles in the 0.1 to 1 μM transition range.
J. Aerosol Sci. 23, 305-308 (1992)
Modern techniques used for particle sizing in the 0.1 to 1 μm transition range are based on different kinds of forces acting upon the particles. In a spiral centrifuge or a low pressure cascade impactor particles are exposed to mechanical forces and can be classified according to their aerodynamic diameter down to about 0.08 resp. 0.03 μm. In a differential mobility analyzer (DMA) particles are separated by electrical forces up to particle diameters of about 1 μm. Submicron particles below about 0.4 μm are often measured in diffusion batteries where particles are classified according to their diffusion coefficient. The diameter derived from the electrical mobility and from the diffusion coefficient can be combined to a common mobility diameter which is only a function of the geometrical particle dimensions. When studying particle behaviour in aerosol systems one has to be cautious in all cases where the forces acting upon the particles during the experiments differ from those ones used for their size characterization. To demonstrate this problem number size distributions of atmospheric aerosols are considered and particle deposition studies in human lungs are reported.
Impact Factor
Scopus SNIP
Scopus
Cited By
Cited By
Altmetric
0.000
0.000
4
Annotations
Special Publikation
Hide on homepage
Publication type
Article: Journal article
Document type
Scientific Article
Language
english
Publication Year
1992
HGF-reported in Year
0
ISSN (print) / ISBN
0021-8502
e-ISSN
1879-1964
Journal
Journal of Aerosol Science
Quellenangaben
Volume: 23,
Issue: Suppl. 1,
Pages: 305-308
Publisher
Elsevier
Reviewing status
Peer reviewed
Institute(s)
Abteilung Biophysikalische Strahlenforschung
Scopus ID
0026965550
Erfassungsdatum
1992-12-31